The wing of the Polish PZL.37 Łoś bomber was made thicker so that bombs would fit inside it. The result surprised its designers: the thicker wing was also more efficient.
Bombs in the wings
Jerzy Dąbrowski's team at the PZL works in Warsaw began designing the Łoś in 1934. They wanted a fast, compact bomber with a heavy load, and part of the answer was to carry bombs not only in the fuselage but in eight small bays in the center section of the wing, sized for the standard 110 kg bomb.
The wing profile they started with turned out to be too thin for the bombs. So the aerodynamicist, Franciszek Misztal, made it thicker — from 12 to 14 percent of the chord — and moved the thickest point further back.
An accidental advantage
Wind-tunnel tests at the Aerodynamic Institute in Warsaw showed something nobody had expected. The reshaped profile had less drag, and kept its low drag across a wider range of angles than a conventional profile. Without setting out to, the team had arrived at a wing with some of the properties of what would later be called a laminar-flow profile.
The Łoś could carry up to 2,580 kg of bombs — more than larger contemporaries such as the early Vickers Wellington — and it was fast for its time. Its double-wheeled main undercarriage, each wheel sprung independently, was designed for Poland's grass airfields.
It came too late and in too small numbers to change the outcome in September 1939, and no original aircraft survives.
The model
COBI's PZL.37 Łoś, set 5780, is a 1:48 model built from 570 blocks. The PZL.23 Karaś (5751) and PZL P.11c (5742) are the Polish light bomber and fighter of the same campaign.
It is available to pre-order. The expected shipping month is shown on the product page, and you can cancel any time before it ships.
Leave a comment